Dell PowerConnect J-EX4200, Руководство по оборудованию

Страница: 43 / 238

SFP+ transceivers, you configure the 10-gigabit operating mode, and for SFP transceivers,
you configure the 1-gigabit operating mode. See “Setting the Mode on an SFP+ Uplink
Module (CLI Procedure)” on page 135.
By default, the SFP+ uplink module operates in the 10-gigabit mode and supports only
SFP+ transceivers. If you have not changed the module from the default setting and you
want to use SFP+ transceivers, you do not need to configure the operating mode.
If the operating mode and the configured mode for an SFP+ uplink module are different,
it is shown in the output of
show chassis pic fpc-slot slot number pic-slot 1
.
Figure 16 on page 27 shows the SFP+ uplink module.
Figure 16: SFP+ Uplink Module
Transceivers are supported in the uplink module’s ports as follows:
• SFP+ transceivers are supported in ports 0 and 2.
• SFP transceivers are supported in all four ports.
The ports that support SFP+ transceivers are labeled 10 G on the uplink module’s
faceplate (see Figure 16 on page 27).
NOTE: When an SFP+ uplink module is operating in 10-gigabit mode:
•
Only the 10-gigabit ports (ports 0 and 2) are enabled.
• You can use only SFP+ transceivers in those ports.
When an SFP+ uplink module is operating in 1-gigabit mode:
• All four ports are enabled.
• You can use only SFP transceivers in all four ports.
The SFP+ uplink module has an LED on the faceplate (labeled
Operating mode LED
in
Figure 16 on page 27) that indicates the operating mode. If the uplink module is operating
27
Chapter 2: Component Descriptions