4. Disassembly and Assembly Procedures
4
.2 Assembly Procedures:
Turn over a power board and put the power board
into the bracket chassis.
Place a bracket chassis base on a protective
cushion, then stick 1pcs Silicon sheet on the position
as the picture below shown.
S2
S1
S4
Take a interface board, connect 2pcs LVDS cable to
the connectors of the interface board, then connect
the cable of the power board to the connector of the
interface board. Turn over the interface board and
locate it into the bracket, then locate all the cables
into the correct position of the bracket. Use a Philips-
head screwdriver to tighten 7pcs screws for locking
the circuit board, .
(No.1 screw size=M4x8, Torque=7
±1
kgfxcm;
No.2~7 screw size=M3x7.5, Torque=7
±1
kgfxcm)
S3
Panel preparation: Take a panel and then examine
the panel surface according to inspection criteria.
Tear off the protective film of the panel screen, and
then turn over the panel to place screen faced down.
S6
S5
Take a mylar to insert the hooks of the bracket to
cover the power board as the following picture shown.
2
5
3
1
7
6
4
Put down the bracket chassis module on the back of
panel module, then connect the two LVDS cables to
the connectors of the panel module.
Use a
4pcs
screws for locking the bracket with panel module.
Philips-head screwdriver to tighten
(No.1~4 screw size=M3x4, Torque=5
±0.5
kgfxcm)
S7
3
2
1
4
