Steps
1. Align the notch on the memory module with the tab on the memory-module slot on the system board.
2. Slide the memory module into the memory-module slot on the system board.
3. Press down on the memory module until the securing clips click, locking the memory module in place.
NOTE:
Repeat steps 1 to 3 if there is a second memory module to be installed into your computer.
Next steps
1. Install the
.
2. Install the
.
After working inside your computer
.
M.2 solid-state drive
Removing the M.2 2230 solid state drive
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
About this task
NOTE:
This procedure applies only to computers shipped with an M.2 2230 solid state drive installed.
NOTE:
The M.2 card installed on your computer depends on the configuration ordered. Supported card configurations on
the M.2 card slot:
●
M.2 2230 solid state drive
●
M.2 2280 solid state drive
24
Removing and installing components
Содержание P152G
