Dell OptiPlex GXa, Руководство по обслуживанию

Страница: 95 / 181

Removing and Replacing Parts on the Low-Profile Chassis 4-21
To remove the SEC cartridge/heat sink assembly, follow these steps:
1. Remove the system power supply.
2. Locate the SEC cartridge/heat sink assembly.
3. Disconnect the microprocessor fan connector from the 3-pin connector
on the system board (labeled “FAN”), located between the SERIAL2
connector and the MONITOR connector (see Figure 4-15).
4. Release the two securing clips near the base of the heat sink from the
metal standoffs, as shown in Figure 4-19.
5. Locate and press inward on the SEC cartridge release latches (located
directly on top of the SEC cartridge adjacent to the heat sink assembly)
until the latches click.
6. Lift the SEC cartridge/heat sink assembly out of its guide bracket
assembly/connector on the system board.
NOTE: When installing the SEC cartridge/heat sink assembly, carefully orient
the assembly and press firmly with up to 25 pounds of force to mate the SEC
cartridge with its connector. Then slide the SEC cartridge release latches out-
ward to lock the assembly onto the metal standoffs.
System Battery
Figure 4-20. System Battery Installation
WARNING: The SEC cartridge/heat sink assembly can get extremely
hot during system operations. Be sure that the assembly has had suffi-
cient time to cool before touching it.
BATTERY
socket
battery