The NIC includes a Remote Wakeup feature that enables the computer to be started by a special local area network (LAN) signal from a server
management console. Remote Wakeup provides remote computer setup, software downloading and installation, file updates, and asset tracking
after hours and on weekends when LAN traffic is typically at a minimum.
The NIC connector on the computer's back panel has the following indicators (see
Figure 1
):
l
A yellow
activity indicator
flashes when the system is transmitting or receiving network data. (A high volume of network traffic may make this
indicator appear to be in a steady "on" state.)
l
A dual-colored
link integrity and speed indicator
, which lights up green when there is a good connection between a 10-Mbps network and
the NIC, or it lights up orange when there is a good connection between a 100-Mbps network and the NIC. When the orange or green
indicator is off, the computer is not detecting a physical connection to the network.
Network Cable Requirements
Your computer's NIC connector (an RJ45 connector located on the back panel) is designed for attaching an unshielded twisted pair (UTP) Ethernet
cable. Press one end of the UTP cable into the NIC connector until the cable snaps securely into place.
Connect the other end of the cable to an RJ45 jack wall plate or to an RJ45 port on a UTP concentrator or hub, depending on your network
configuration.
A 100-Mbps network requires Category 5 wiring and connectors. A 10-Mbps network requires Category 3 or Category 5 wiring and connectors.
Video Connector
The system uses a 15-pin high-density D-subminiature connector on the back panel for attaching a video graphics array (VGA)-compatible
monitor to your system.
Controls and Indicators
Figure 2 shows the controls and indicators located on the front panel of your computer.
Figure 2. Controls and Indicators
Diskette-Drive Access Indicator
The diskette-drive access indicator lights up when the drive is reading data from or writing data to a diskette. Wait until the access indicator turns
off before removing a diskette from the drive.
Power Button
The power button controls the system's AC input power.
For Microsoft Windows 95, the power button functions as follows:
l
When the computer is turned off, pushing the power button turns on the computer.
l
When the computer is turned on, pushing the power button turns off the computer.
For Microsoft Windows 98 and Windows NT, you can configure the power button's function through the basic input/output system (BIOS). If you
1
Diskette-drive access indicator
2
Power button
3
Power indicator
4
Reset button
5
Hard-disk drive access indicator
6
Cover release button
