4. Install the following components:
a)
b)
c)
d)
5. Follow the procedure in
After working inside your computer
.
Power supply unit - PSU
Removing the power supply unit -PSU
1. Follow the procedure in
Before working inside your computer
.
2. Remove the following components:
a)
b)
c)
d)
3. To release the PSU cable:
a) Remove the single (M3x5) screw securing the power supply socket to the I/O bracket [1].
b) Slide the power supply socket away to remove it from the system [2].
c) Unroute the power supply cables from the retention clips in the chassis [3].
d) Disconnect the power supply cable from the socket on the system board [4].
NOTE:
Press the clip downward to release the power supply cable from the system board.
56
Removing and Installing components
Содержание OptiPlex 5270 All-in-One
Страница 1: ...Dell OptiPlex 5270 All in One Service Manual Regulatory Model W20B Regulatory Type W20B001 ...
Страница 42: ...4 Lift the heat sink off the system board and display assembly base 42 Removing and Installing components ...
Страница 54: ...4 Pry and lift the base cover off the middle frame 54 Removing and Installing components ...
Страница 58: ...b Slide the PSU and lift it away from the chassis 58 Removing and Installing components ...
