3.
From the
TPM Security
option, select
On with Pre-boot Measurements
.
4.
From the
TPM Command
option, select
Activate
.
5.
Save the settings.
6.
Restart your system.
7.
Enter
System Setup
again.
8.
On the
System Setup Main Menu
screen, click
System BIOS
→
System Security Settings
.
9.
From the
Intel TXT
option, select
On
.
System board
Removing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be
performed only by Dell certified service technicians.
CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may
be prompted to create a recovery key during program or System Setup. Be sure to create and
safely store this recovery key. If you replace this system board, you must supply the recovery key
when you restart your system or program before you can access the encrypted data on your hard
drives.
CAUTION: Do not attempt to remove the TPM plug-in module from the system board. After the
TPM plug-in module is installed, it is cryptographically bound to that specific system board. Any
attempt to remove an installed TPM plug-in module breaks the cryptographic binding, and it
cannot be re-installed or installed on another system board.
1.
Follow the safety guidelines listed in Safety instructions section.
2.
Keep the Phillips #2 screwdriver ready.
3.
Follow the procedure listed in the Before working inside your system section.
4.
Remove the following components:
a.
cooling shroud
b.
memory modules
c.
cooling fan cables
d.
expansion cards
e.
expansion card riser
f.
heat sink and processor
g.
iDRAC port card, if installed
h.
internal dual SD module, if installed
Steps
1.
Disconnect all cables from the system board.
118
