Dell Networking S6000 System, Справочное руководство

Страница: 45 / 1510

Usage
Information You can activate VRF application on a device by using the
feature vrf
command
in CONFIGURATION mode. The
no feature vrf
command is not supported on
any of the platforms.
Example
Dell#show feature
Feature State
------------------------------
VRF enabled
Command Modes
To navigate and launch various CLI modes, use specific commands. Navigation to these modes is
described in the following sections.
BGP ADDRESS-FAMILY Mode
To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, refer to
Border Gateway Protocol IPv4 (BGPv4) .
To enter BGP ADDRESS-FAMILY mode:
1. Verify that you are logged in to ROUTER BGP mode.
2. Enter the command
address-family
3. Enter the protocol type.
• For IPv4, enter
ipv4 multicast
. The prompt changes to include (conf-router_bgp_af) for IPv4.
CLASS-MAP Mode
To create or configure a class map, use CLASS-MAP mode. For more information, refer to Policy-Based
QoS Commands .
To enter CLASS-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
class-map
command then enter the class map name. The prompt changes to include
(config-class-map).
You can return to CONFIGURATION mode by using the
exit
command.
CONFIGURATION Mode
In EXEC Privilege mode, use the
configure
command to enter CONFIGURATION mode and configure
routing protocols and access interfaces.
To enter CONFIGURATION mode:
1. Verify that you are logged in to EXEC Privilege mode.
2. Enter the
configure
command. The prompt changes to include (conf).
From this mode, you can enter INTERFACE mode by using the
interface
command.
CLI Basics
45