Dell Networking S6000 System, Справочное руководство

Страница: 1374 / 1510

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you enable
logging synchronous
, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Related
Commands
logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
S6000
Syntax
logging trap [ level ]
To return to the default values, use the
default logging trap
command.
To disable logging, use the
no logging trap
command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters:
emergencies
,
alerts
,
critical
,
errors
,
warnings
,
notifications
,
informational
, or
debugging
. The default is 6 or informational .
Defaults 6 or informational
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
1374
Simple Network Management Protocol (SNMP) and Syslog