Dell N2128PX-ON, Руководство по началу работы

Страница: 40 / 201

38
Getting Started Guide
Performing the N3132PX-ON Initial Configuration
The initial configuration procedure is based on the following assumptions:
• The Dell Networking switch was never configured before.
• The Dell Networking switch booted successfully.
• The console connection was established, and the Dell Easy Setup Wizard
prompt appears on the screen of a VT100 terminal or terminal equivalent.
The initial switch configuration is performed through the console port. After
the initial configuration, you can manage the switch from the already-
connected console port or remotely through an interface defined during the
initial configuration.
NOTE:
The switch is not configured with a default user name or password. The
default IP address is set to DHCP for the out-of-band
(OOB)
port.
Before setting up the initial configuration of the switch, obtain the following
information from your network administrator:
• The IP address to be assigned to the management interface.
• The IP subnet mask for the network.
• The IP address of the management interface default gateway.
These settings are necessary to allow the remote management of the switch
through Telnet (Telnet client) or HTTP (Web browser).
Enabling Remote Management
The N3132PX-ON switch’s front panel contains a Gigabit Ethernet port for
OOB management. The OOB port is located to the right of the console port.
On the N3132PX-ON switches, use the OOB port or any of the switch ports
on the front panel for in-band management. By default, all in-band ports are
members of VLAN 1.
The Dell Easy Setup Wizard includes prompts to configure network
information for the OOB management interface on the N3132PX-ON switch
and the VLAN 1 interface on the N3132PX-ON switches. For either
management interface, you can assign a static IP address and subnet mask or
enable DHCP and allow a network DHCP server to assign the information.
Refer to the CLI Reference Guide for commands to configure network
information.