Figure 22. Installing the N30xx in a Front-Rack Configuration
1
Switch
2
Rail bracket
3
Mounting screw
Installing as a Free-standing Switch
NOTE:
Dell Networking strongly recommends mounting the switch in a rack.
Install the switch on a flat surface if you are not installing it in a rack. The surface must be able to support the weight of the switch and the
switch cables. The switch is supplied with four self-adhesive rubber pads.
1
Attach the self-adhesive rubber pads on each location marked on the bottom of the switch.
2
Set the switch on a flat surface. Make sure that it has proper ventilation by leaving 5 cm (2 inches) on each side and 13 cm (5 inches)
at the back.
Stacking on N30xx Series Switches
This section explains how to stack multiple N30xx series switches.
N30xx Series Installation
35