Dell N1100-ON, Справочное руководство

Страница: 693 / 2332

Layer 2 Switching Commands
693
match srcip
Use the match srcip command in Class-Map Configuration mode to add to
the specified class definition a match condition based on the source IP
address of a packet.
NOTE:
This command is not available on the N1500 Series switches.
Syntax
match srcip ipaddr ipmask
• ipaddr — Specifies a valid IP address.
• ipmask — Specifies a valid IP address bit mask. Note that although this IP
address bit mask is similar to a subnet mask, it does not need to be
contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
Only one srcip matching criteria can be specified. To remove the matching
criteria, delete the class map.
Example
The following example displays adding a match condition for the specified IP
address and address bit mask.
console(config-classmap)#match srcip 10.240.1.1 10.240.0.0
match srcip6
The match srcip6 command adds to the specified class definition a match
condition based on the source IPv6 address of a packet.
NOTE:
This command is not available on the N1500 Series switches.