Dell N1100-ON, Справочное руководство

Страница: 595 / 2332

Layer 2 Switching Commands
595
Peer IP address............................10.130.14.55
Source IP address..........................10.130.14.54
UDP port...................................50000
Peer detection admin status................Enabled
Peer detection operational status..........Up
Peer is detected...........................True
Configured Tx interval.....................500 milliseconds
Configured Rx timeout......................2000 milliseconds
Operational Tx interval....................500 milliseconds
Operational Rx timeout.....................2000 milliseconds
show vpc role
Use the show vpc role command to display information about the keepalive
status and parameters. The role of the MLAG switch as well as the system
MAC and priority are displayed.
Syntax
show vpc role
Default Configuration
There is no default configuration for this command.
Command Modes
Privileged Exec mode and above
User Guidelines
A VPC domain ID must be configured for this command to display the VPC
role.
Example
console# show vpc role
Self
----
VPC domain ID...................................1
Keepalive config mode.......................... Enabled
Keepalive operational mode..................... Enabled
Role Priority.................................. 100
Configured VPC MAC..............................<AA:BB:CC:DD:EE:FF>
Operational VPC MAC.............................<AA:BB:CC:DD:EE:FF>