Dell N1100-ON, Справочное руководство

Страница: 557 / 2332

Layer 2 Switching Commands
557
no lldp receive
Default Configuration
The default lldp receive mode is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable the LLDP receive capability.
console(config-if-Gi1/0/3)#lldp receive
lldp timers
Use the lldp timers command in Global Configuration mode to set the
timing parameters for local data transmission on ports enabled for LLDP. To
return any or all parameters to factory default, use the no form of this
command.
Syntax
lldp timers [ interval
transmit-interval
] [ hold
hold-multiplier
] [ reinit
reinit-
delay
]
no lldp timers [ interval ] [ hold ] [ reinit ]
• transmit-interval — The interval in seconds at which to transmit local data
LLDPDUs. (Range: 5–32768 seconds)
• hold-multiplier — Multiplier on the transmit interval used to set the TTL
in local data LLDPDUs. (Range: 2–10)
• reinit-delay — The delay in seconds before reinitialization. (Range: 1–10
seconds)
Default Configuration
The default transmit interval is 30 seconds.