Dell N1100-ON, Справочное руководство

Страница: 344 / 2332

Layer 2 Switching Commands
344
The administrator can configure the rate and burst interval. Rate limiting is
configured independently on each physical interface and may be enabled on
both trusted and untrusted interfaces. The rate limit is configurable in the
range of 0-300 packets per second and the burst interval in the range of 1-15
seconds. In general, a rate limit of under 100 pps is valid for untrusted
interfaces.
Examples
console(config-if-Gi1/0/1)#ip dhcp snooping limit rate 100 burst interval 1
ip dhcp snooping log-invalid
Use the ip dhcp snooping log-invalid command to enable logging of DHCP
messages filtered by the DHCP Snooping application. Use the no form of this
command to disable logging.
Syntax
ip dhcp snooping log-invalid
no ip dhcp snooping log-invalid
Default Configuration
Logging of filtered messages is disabled by default.
Invalid DHCP messages are not logged by default.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
This command is available in physical interface configuration mode or port
channel configuration mode.
Example
console(config-if-Gi1/0/1)#ip dhcp snooping log-invalid
console(config-if-Gi1/0/1)#no ip dhcp snooping log-invalid