Switch Management Commands
1851
sntp broadcast client enable
Use the
sntp broadcast client enable
command in Global Configuration
mode to enable a Simple Network Time Protocol (SNTP) Broadcast client. To
disable an SNTP Broadcast client, use the
no
form of this command.
Syntax
sntp broadcast client enable
no sntp broadcast client enable
Default Configuration
The SNTP Broadcast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables a Simple Network Time Protocol (SNTP)
Broadcast client.
console(config)# sntp broadcast client enable
sntp client poll timer
Use the
sntp client poll timer
command in Global Configuration mode to set
the polling time for the Simple Network Time Protocol (SNTP) client. To
return to the default settings, use the
no
form of this command.
Syntax
sntp client poll timer
seconds
no sntp client poll timer
• seconds — Polling interval. (Range: 64-1024 seconds, in powers of 2, i.e.,
64, 128, 256, 512 or 1024.)
Содержание N1100-ON
