Dell N1100-ON, Справочное руководство

Страница: 1675 / 2332

Layer 3 Routing Commands
1675
redistribute (OSPF)
Use the redistribute command in Router OSPF Configuration mode to
configure OSPF protocol to allow redistribution of routes from the specified
source protocol/routers. Use the no version of the command to disable
redistribution from the selected source or to reset options to their default
values.
Syntax
redistribute {protocol}[ metric metric-value ] [ metric-type type-value ] [ tag
tag-value ] [ subnets ]
no redistribute { protocol } [ metric ] [ metric-type ] [ tag ] [ subnets ]
• protocol —One of the following:
– static—Specifies that static routes are to be redistributed.
– connected—Specifies that connected routes are to be redistributed.
– bgp—Specifies BGP originated routes are to be redistributed.
– rip—Specifies RIP originated routes are to be redistributed.
• static —Specifies that static routes are to be redistributed.
– connected —Specifies the connected routes are to be redistributed.
• metric-value—Specifies the metric to use when redistributing the route.
(Range: 0–16777214)
• type-value—One of the following:
– Type 1 external route.
– Type 2 external route.
• tag-value—Inserts the specified tag value into redistributed routes.(Range:
0–4294967295)
• subnets —Specifies whether to redistribute the routes to subnets.
Default Configuration
The default tag value is 0.
There is no default metric or route map configured.