Dell N1100-ON, Справочное руководство

Страница: 1138 / 2332

Data Center Technology Commands
1138
In order to reduce flapping of configuration information, if the configuration
source port is disabled, disconnected or loses LLDP connectivity, the system
clears the selection of configuration source port (if not manually selected)
and enables the willing bit on all auto-upstream ports. The configuration on
the auto-configuration ports is not cleared (configuration holdover). If the
user wishes to clear the configuration on the system in this scenario, the user
can put the configuration source port into manual mode.
When a new port is selected as configuration source, it is marked as the
configuration source, the DCBX configuration is refreshed on all auto-
configuration ports and each port may begin configuration negotiation with
their peer again (if any information has changed).
Commands in this Section
This section explains the following commands:
Data Center Bridging Capability Exchange
Commands
datacenter-bridging
Use the datacenter-bridging command for an Ethernet interface in order to
enter the DataCenterBridging mode. Priority-Flow-Control is configurable
from within the DataCenterBridging mode.
Data Center Bridging Capability Exchange Commands
datacenter-bridging lldp dcbx port-role
lldp dcbx version show lldp tlv-select
lldp tlv-select dcbxp (dcb enable) show lldp dcbx
Enhanced Transmission Selection Commands
classofservice traffic-class-group traffic-class-group weight
traffic-class-group max-bandwidth show classofservice traffic-class-group
traffic-class-group min-bandwidth show interfaces traffic
traffic-class-group strict show interfaces traffic-class-group