Dell Latitude E7270, Руководство пользователя

Страница: 28 / 62

6. To remove the display assembly:
a. Remove the screws that secure the display assembly to the computer [1].
b. Open the display assembly [2] and lift the display assembly to remove it from the computer [3].
Installing the display assembly
1. Insert the display hinges into the slots on the computer.
NOTE: This should be done with the display assembly in open position. Ensure that the cables are free from the
hinge slots and computer.
2. Close the display assembly.
3. Insert the WLAN and WWAN cables through the slot on the computer
4. Route the display assembly cable through the slot and routing clips on the computer.
5. Tighten the screws to secure the display assembly to the computer.
6. Route the WLAN and WWAN cables through the routing channel on the system board.
7. Connect the WLAN and WWAN cables to the connectors on the WLAN and WWAN cards.
8. Connect the display cable to the connector on the system board.
9. Place the display cable bracket over the connector and tighten the screw to secure the display cable to the system board.
10. Tighten the screws to secure the display assembly to the computer.
11. Install the display hinge brackets and tighten the screws to secure it to the computer.
12. Install the:
a.
WLAN card
b. WWAN card
c. battery
d. base cover
13. Follow the procedure in After working inside your computer .
28