Dell Latitude CPi R Series, Руководство по обслуживанию

Страница: 36 / 45

Dell Latitude CPt C-Series/CPi R-Series Service Manual 27
)LJXUH 0LFURSURFHVVRU 0RGXOH
4. Remove the two 4-mm screws securing the thermal cooling assembly to
the microprocessor module (see Figure 19).
5. Loosen the three captive screws securing the microprocessor shield to the
microprocessor module.
6. Remove the microprocessor shield.
7. Rotate the arm of the thermal cooling assembly up and away from the
microprocessor module.
&$87,21 3XOO WKH PRGXOH VWUDLJKW XS 'R QRW PRYH WKH WRRO IURP
VLGH WR VLGH WR H[WUDFW WKH SURFHVVRU ERDUG
8. Use a microprocessor extractor tool to remove the microprocessor
module.
The tool fits on the left side of the module aligned with white marks on the
front and back edge of the processor board (see Figure 19).
9. Remove any PC Cards or plastic blanks from the PC Card slot.
10. Verify that the PC Card ejectors do not extend from the PC Card slot.
11. Remove the following two screws from the system board assembly
(see Figure 18):
‡
The 4-mm screw with captive washer located on the far left side of the
computer between the hard-disk drive assembly and the PC Card slot.
4-mm screws (2)
captive screws (3)
thermal cooling
assembly arm
microprocessor shield
white marks on the
microprocessor board (2)
microprocessor module