Dell Latitude 5320, Руководство по обслуживанию

Страница: 55 / 116

Steps
1. Unroute the antenna cables.
2. Disconnect the IR camera cable from its connector on the system board.
3. Unroute the IR camera cable from underneath the fan.
4. Remove the conductive tape covering the eDP cable.
5. Open the latch and disconnect the display eDP cable its connector on the system board.
6. Remove the single (M2x4) screw that secures the display cable bracket to the system board to release the display cable.
7. Remove the two screws (M2.5x4) that secure the left-display hinge to the system board.
8. Remove the two screws (M2.5x4) that secure the right-display hinge to the system board.
9. Open the display hinges at an angle of 90 degrees.
10. Gently slide the palm-rest and keyboard assembly off the display assembly carefully.
Installing the display assembly (2-in-1)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display assembly for 2-in-1 and provides a visual representation of the
installation procedure.
Removing and installing components 55