3
Affix the tape on the heat sink.
4
Connect the eDP cable to the connectors on the system board.
5
Insert the wireless antenna cables through the routing hole on the chassis.
6
Replace the display assembly M2.0X3 screws at the bottom and back of the computer.
7
Align the display hinge cap and tighten the M2.5x4.0 screws to secure it to the computer.
8
Connect the antenna cables to the connectors.
9
Install the:
a
b
c
d
e
f
g
h
10 Follow the procedure in
After working inside your computer
.
Power switch board
Removing the power switch board
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
c
d
e
f
3
To remove power switch board:
a Disconnect the power switch board cable from the computer [1].
b Remove the M2.0X3 screws that secure power switch board to the computer [2].
c Remove the power switch board from the computer [3].
Disassembly and reassembly
39
