Dell Inspiron 5481, Руководство по обслуживанию

Страница: 70 / 96

Removing the system board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer . After working inside your computer, follow the instructions in After
working inside your computer . For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance .
NOTE: Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE: Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program. You
must make the appropriate changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
Prerequisites
1. Remove the base cover .
2. Remove the battery .
3. Remove the memory modules .
4. Remove the coin-cell battery .
5. Remove the solid-state drive/Intel Optane memory module .
6. Remove the fan .
7. Remove the heat sink .
8. Remove the wireless card .
Procedure
1. Peel off the tape that secures the I/O-board cable to the system board.
2. Open the latch, and disconnect the I/O-board cable from the system board.
3. Remove the touch-screen board cable and the display cable from the routing guides on the palm-rest and keyboard
assembly.
4. Peel off the tapes that secure the display cable and touch-screen board cable to the system board.
5. Disconnect the touch-screen board cable from the system board.
6. Open the latches, and disconnect the display cable from the system board.
42
70 Removing the system board