About this task
NOTE:
This procedures only applies if you are installing a 4-cell battery (64 Wh) into your computer.
The following image(s) indicate the location of the 4-cell battery (64 Wh) and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment posts, place the 4-cell battery on the palm-rest and keyboard assembly.
2. Align the screw holes on the 4-cell battery with the screw holes on the palm-rest and keyboard assembly.
3. Replace the five screws (M2x3) that secure the 4-cell battery to the palm-rest and keyboard assembly.
4. Connect the battery cable to the system board.
Next steps
1. Install the
.
After working inside your computer
.
Removing the 6-cell battery (87 Wh)
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
NOTE:
This procedures only applies for computers shipped with a 6-cell battery (87 Wh) installed.
The following image(s) indicate the location of the 6-cell battery (87 Wh) and provides a visual representation of the removal
procedure.
Removing and installing components
35