Dell Inspiron 14 5410, Руководство по обслуживанию

Страница: 42 / 82

Steps
1. Slide the display assembly at an angle, and place the display assembly on the palm-rest and keyboard assembly.
2. Replace the four screws (M2.5x3.5) that secure the display hinges to the palm-rest and keyboard assembly.
3. Route the display cable through the routing guide on the palm-rest and keyboard assembly.
4. Slide the display cable into the connector on the system board and close the latch to secure the cable.
5. Connect the display-cable connector to the system board and close the latch to secure the cable.
6. Adhere the tape that secures the display cable to the system board.
Next steps
1. Install the base cover .
2. Follow the procedure in After working inside your computer .
3. Exit Service Mode .
Power-adapter port
Removing the power-adapter port
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Enter Service Mode .
3. Remove the base cover .
4. Remove the display assembly .
About this task
The following image indicates the location of the power-adapter port and provides a visual representation of the removal
procedure.
Steps
1. Disconnect the power-adapter port cable from the system board.
2. Peel the tape that secures the power-adapter port cable to the system board.
42 Removing and installing components