Steps
1. Disconnect the speaker cable from the system board.
2. Disconnect the keyboard-backlight cable and the keyboard cable from the system board.
3. Note the routing of the speaker cable, and remove the speaker cable from the routing guides on the palm-rest and keyboard assembly.
NOTE:
Note the position of the rubber grommets before lifting the speakers.
4. Lift the speakers, along with the cable, off the palm-rest and keyboard assembly.
Installing the speakers (in 3-cell battery configuration)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest and keyboard assembly.
50
Removing and installing components
