Steps
1. Connect the battery cable to the system board, if applicable.
2. Place the base cover on top of the palm-rest and keyboard assembly.
3. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover
into place.
4. Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
5. Replace the five (M2x4) screws that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in
after working inside your computer
.
Battery
Removing the 4-cell battery
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Steps
1. Peel the tape and disconnect the battery cable, if applicable.
2. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery, along with its cable off the palm-rest and keyboard assembly.
16
Removing and installing components
