Back to Contents Page
Replacing the Display
Dell™ Inspiron™ 1210 Service Manual
Replacing the Display Assembly
Replacing the Display Bezel
Replacing the Display Panel
Replacing the Display Assembly
1.
Follow the instructions in "Before You Begin" on page 9.
2.
Remove the palm rest. See
Replacing the Palm Rest
.
3.
Pull the display cable tab to disconnect the display cable from the system board connector.
4.
Disconnect the 2-in-1 camera and LVDS cable from the system board connector.
5.
Remove the four M2.5 x 3-mm screws from the display hinges.
6.
Lift and remove the display assembly from the computer base.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTE:
Note how the display cable and the 2-in-1 camera and LVDS cable have been connected on the system board.
1
display
2
M2.5 x 3-mm screws (4)
3
2-in-1 cable: camera end
4
2-in-1 cable: LVDS end
Содержание Inspiron 1210
Страница 13: ...Back to Contents Page ...
Страница 23: ...Back to Contents Page ...
Страница 30: ...Back to Contents Page ...