Dell IDRAC6, Руководство пользователя

Страница: 96 / 472

96
Configuring iDRAC6 Enterprise Using the Web Interface
b
Enter an IP address in the appropriate IPv4 or IPv6 Destination IP
Address box.
NOTE:
The destination community string must be the same as iDRAC6
community string.
c
Click Apply .
NOTE:
To successfully send a trap, configure the Community String value.
The Community String value indicates the community string to use in a Simple
Network Management Protocol (SNMP) alert trap sent from iDRAC6. SNMP
alert traps are transmitted by iDRAC6 when a platform event occurs. The
default setting for the
Community String is Public .
d
To test the configured alert, click Send .
e
To add an additional destination IP address, repeat step a through
step d. You may specify up to four IPv4 and four IPv6 destination
addresses.
Configuring E-Mail Alerts
1
Log in to iDRAC6 Web interface.
2
Ensure that you followed the procedures in "Configuring Platform Event
Filters (PEF)."
3
Click System , and then click the Alert Management tab.
The Platform Events screen appears.
4
Click Email Alert Settings .
The Email Alert Settings screen appears.
5
Configure your e-mail alert destination.
a
Select the Enabled check box for the first undefined email alert.
b
Enter a valid email address in the Destination Email Address field.
c
Click Apply .
NOTE:
To successfully send a test e-mail, the SMTP (Email) Server IP
Address must be configured in the SMTP (Email) Server Address Settings
section of the Email Alert Settings screen. The IP address of the SMTP Server
communicates with iDRAC6 to send e-mail alerts when a platform event
occurs.
d
Click Send to test the configured e-mail alert (if desired).