Dell G7 7700, Руководство по обслуживанию

Страница: 51 / 96

Steps
1. Align the screw hole on the I/O board with the screw hole on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x4) that secure the I/O board to the palm-rest and keyboard assembly.
3. Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
4. Connect the fingerprint-reader cable to the I/O-board and close the latch to secure the cable.
Next steps
1. Install the hard drive .
2. Install the base cover .
3. Follow the procedure in After working inside your computer .
G key
Removing the G key
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the base cover .
3. Remove the rear cover .
4. Remove the rear-cover bracket .
5. Remove the processor fan .
6. Remove the heat sink .
7. Remove the power-adapter port .
About this task
The following image indicates the location of the G key and provides a visual representation of the removal procedure.
Removing and installing components 51