Dell FS7500, Установка и настройка

Страница: 30 / 88

Positioning the ControllerRails
Orient the left and right controller rails in the position in which you will install them in the rack. Make sure that
the FRONT label is toward the front of the rack. Make sure that the label is not upside down.
Attaching the Controller Rails to the Rack
See Figure 22 and follow these steps for each rail:
1. Verify where to place the controller rails in the rack. See Guidelines for Installing Mounting Rails in a Rack
on page 13 .
2. From the front of the rack, fit the rear portion of the rail in the desired U holes on the outside of the rear post
and pull the rail forward until the latch locks in place (Callout 1).
3. Pull the front end of the rail past the front post.
4. Fit the front portion of the rail in the desired U holes on the post and push the rail into the rack until the latch
locks in place (Callout 2). You should hear the latch click twice. Make sure that the front bracket is flush
with the rack.
Check both ends of the rails to ensure they are fully seated in the same rack hole positions and that the rails are
level.
Figure 22: Attaching the Controller Rails to a Rack
24
EqualLogic FS7500 Installation and Setup
2 Hardware Rack Mounting