Dell FS7500, Установка и настройка

Страница: 29 / 88

EqualLogic FS7500 Installation and Setup
2 Hardware Rack Mounting
Figure 21: Attaching the BPS Bezel
Steps for Installing an FS7500 Controller in a Rack
Before you begin, obtain the FS7500 Controller rail kit. See Shipping Box Contents on page 7 .
Caution:
You need at least two persons to install the controller in a rack.
1. Position the left and right controller rails in the orientation in which you will install the rails. See Positioning
the ControllerRails on page 24 .
2. Attach the controller rails to the rack. See Attaching the Controller Rails to the Rack on page 24 .
3. Attach the controller to the rails and slide the controller into the rack. See Installing the Controllers Into the
Rack on page 25 .
4. Secure the controller to the rack. See Securing the Controllers to the Rack on page 25 .
5. Attach the bezel to the controller. See Attaching the Controller Bezel on page 26 .
These steps are described in detail in the following sections.
Note: If you are installing the controller into a shallow rack (less than 1 m deep), you may remove the cable
management brackets on the controller rails. See Removing the Brackets From the Controller Rails on page 73
for information about how to remove the brackets.
23