Dell Force10 TeraScale C Series, Справочное руководство

Страница: 651 / 1640

IPv4 Routing | 651
ip redirects
e
Enable the interface to send ICMP redirect messages.
Syntax ip redirects
To return to default, enter no ip redirects .
Defaults Disabled
Command Modes INTERFACE
Command
History
Usage
Information
This command is available for physical interfaces and port-channel interfaces on the E-Series.
ip route
c e s
Assign a static route to the switch.
Syntax ip route vrf {vrf instance} destination mask
{
ip-address
|
interface
[
ip-address
]} [
distance
]
[
permanent
] [
tag tag-value
]
To delete a specific static route, use the
no ip route destination mask
{
address | interface
[
ip-address
]} command.
To delete all routes matching a certain route, use the
no ip route destination mask
command.
Parameters
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series
Note:
This command is not supported on default VLAN ( default vlan-id command).
vrf name
(OPTIONAL) E-Series Only : Enter the keyword
vrf
followed by the VRF Instances
name to tie the static route to the VRF instance.
destination Enter the IP address in dotted decimal format of the destination device.
mask Enter the mask in slash prefix formation (/x) of the destination device’s IP address.
ip-address Enter the IP address in dotted decimal format of the forwarding router.