Dell Force10 TeraScale C Series, Справочное руководство

Страница: 365 / 1640

Border Gateway Protocol IPv4 (BGPv4) | 365
Parameters
Defaults Not configured.
Command Modes ROUTER BGP
Usage
Information
With FTOS version 8.3.1.0 and later, the redistribute command can be used to advertise the IGP cost as
the MED
on redistributed routes
. When the route-map is set with metric-type internal and applied
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-group
will have IGP cost set as MED.
When you enter redistribute isis process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This feature is
not supported by an RFC.
Command
History
router bgp
c e s
Enter ROUTER BGP mode to configure and enable BGP.
Syntax router bgp as-number
To disable BGP, use the
no router bgp as-number
command.
Parameters
Defaults Not enabled.
Command Modes CONFIGURATION
Example Figure 12-4. Command Example: router bgp
process-id
Enter the number of the OSPF process.
Range: 1 to 65535
match external
{
1
|
2
}
(OPTIONAL) Enter the keywords match external to redistribute OSPF
external routes. You can specify 1 or 2 to redistribute those routes only.
match internal
(OPTIONAL) Enter the keywords
match internal
to redistribute OSPF
internal routes only.
route-map map-name
(OPTIONAL) Enter the keywords
route-map
followed by the name of a
configured Route map.
Version 8.3.1.0 Introduced ability to substitute IGP cost for MED when a peer/peer-group
outbound route-map is set as internal.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
as-number
Enter the AS number.
Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte)
or
0.1-65535.65535 (Dotted format)
(conf)#router bgp 3
(conf-router_bgp)#