Dell ExaScale E600i, Руководство по установке

Страница: 52 / 68

52 | Alarms
www.dell.com | support.dell.com
AC Power Supplies and Alarms
During system boot, if the redundant power supply (the fourth power supply) is missing or fails, the
FTOS does not generate any alarm messages since the minimum configuration of three power supplies is
operating. Yet, if a fourth AC power supply is installed, and later one of the four power supplies is
removed or fails, the system generates a minor alarm.
If only three power supplies are installed and one of them fails while the E-Series is operating, the
software generates a major alarm and an SNMP trap, lights the major LED, and activates the audible
alarm.
When you operate the E-Series with three AC power supplies and six or more line cards, the software
lists a redundancy alarm on the console and in the
show alarms
command output. All line cards operate
normally.
Line Card Hardware failure major (red) major amber no
Exceeds high temperature limit major (red) major unlit yes
Exceeds warning temperature limit minor (amber) minor green yes
Individual interface fails minor (amber) reported amber
a
no
RPM (Non-redundant Configuration with 1 RPM)
Exceeds high temperature limit major (red) major unlit yes
Exceeds warning temperature limit minor (amber) minor green no
RPM fails but CP is ok major (red) major amber yes
SFMs (Redundant Configuration with 5 SFMs)
Exceeds high temperature limit major (red) major unlit yes
Exceeds warning temperature limit minor (amber) minor green no
Any card fails minor (amber) minor amber no
Any card removed minor (amber) minor unlit no
SFMs (Non-Redundant Configuration with 4 SFMs)
Exceeds high temperature limit major (red) major unlit yes
Exceeds warning temperature limit minor (amber) minor green no
Any card fails major (red) major amber yes
Any card removed major (red) major unlit yes
a. The interface’s Link LED is unlit.
Table B-1. Alarm Events and Reporting
Module Alarm Event Alarm LED Reported in
event log Status LED
on Module Audible
Alarm?