Dell EMC XC Core XC450, Инструкция по установке и обслуживанию

Страница: 33 / 109

Next steps
1. Replace the air shroud .
2. Follow the procedure listed in After working inside your system .
Intrusion switch module
This is a service technician replaceable part only.
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the air shroud .
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
Figure 25. Removing the intrusion switch module
Next steps
Replace the intrusion switch .
Installing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the air shroud .
Installing and removing system components 33