Dell E70S, Инструкция по установке и обслуживанию

Страница: 182 / 238

Next steps
1. Replace the BOSS S2 card carrier blank or install BOSS S2 card carrier .
Installing the BOSS S2 card carrier blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
Steps
Align the blank with the BOSS S2 module bay and push it into the bay until it clicks into place.
Figure 184. Installing the BOSS S2 card carrier blank
Removing the BOSS S2 module
The procedure to remove is the BOSS S2 module with 4 x 2.5-inch rear drive module is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
182 Installing and removing system components