Figure 33. Installing a drive into the drive carrier
Next steps
1.
2.
3. Follow the procedure listed in
After working inside your system
Removing a 2.5-inch drive from the 3.5-inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3.
Remove 3.5-inch drive adapter from the 3.5-inch drive carrier.
NOTE:
A 2.5 inch hot swappable drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch hot
swappable drive carrier.
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
2. Remove the drive from the 3.5-inch drive adapter.
Installing and removing system components
57
