Figure 94. Removing the M.2 SSD module
Next steps
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
3.
.
4.
from the riser.
NOTE:
The procedure to remove the BOSS card is similar to removing an expansion card.
Steps
1. Align the M.2 SSD module at an angle with the BOSS card connector.
2. Insert the M.2 SSD module until it is firmly seated in the BOSS card connector.
3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the BOSS card.
NOTE:
The numbers on the image does not depict the exact steps. The numbers are just for representation of
sequence.
90
Installing and removing system components
