Dell E36S Series, Руководство пользователя

Страница: 69 / 120

Figure 32. Installing the optical drive
1. SATA and power cable 2. release tab
3. optical drive 4. hard drive cage
Next steps
1. Install the hard drive cage.
2. If disconnected, reconnect the disconnected data and power cables to the hard drives and optical drive.
3. Install the bezel.
4. Reconnect the peripherals disconnected from the control panel assembly.
5. Follow the procedure listed in
After working inside your system on page 43.
Related tasks
Removing the bezel on page 45
Removing the hard drive cage on page 53
Removing the optical drive blank and filler on page 64
Installing the optical drive on page 68
Installing the hard drive cage on page 54
Installing the bezel on page 46
System memory
Your system supports DDR4 ECC unbuffered DIMMs (UDIMMs).
NOTE: MT/s indicates memory module speed in Mega Transfers per second.
Memory bus operating frequency can be 1600 MT/s, 1866 MT/s, 2133 MT/s, or 2400 MT/s depending on the following factors:
• System profile selected (for example, Performance Optimized, Custom, or Dense Configuration Optimized)
• Maximum supported memory module frequency of the processors
The system contains four memory sockets — two sets of 2–sockets each. Each 2–socket set is organized into one channel. In each 2-
socket set, the first socket release lever is marked white and the second socket release lever is marked black.
Installing and removing system components 69