Figure 61. Removing an AC PSU
1
release latch
2
PSU cable connector
3
PSU
4
power connector
5
PSU handle
Next steps
1
Install the AC power supply unit.
2
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing an AC power supply unit
After working inside your system
Installing an AC power supply unit
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE:
The maximum output power (shown in watts) is listed on the PSU label.
1
For systems that support redundant power supply units (PSUs), ensure that both the PSUs are of the same type and have the same
maximum output power.
2
If installed, remove the PSU blank.
Steps
1
Slide the PSU into the chassis until the PSU is fully seated and the release latch snaps into place.
2
If applicable, relatch the cable management arm.
For information about the cable management arm, see the rack documentation of your system.
3
Connect the power cable to the PSU, and plug the cable into a power outlet.
Installing and removing system components
123
