7
Cisco Catalyst 3850 Switch Configuration Guide for Dell PS Series SANs | SCG3299
The enable password is used when you do not specify an enable secret password,
with some older software versions, and some boot images.
Enter enable password:
<password>
The virtual terminal password is used to protect access to the router over a
network interface.
Enter virtual terminal password:
<password>
Setup account for accessing HTTP server? [yes]:
no
Configure SNMP Network Management? [no]:
<Enter your choice>
Note:
The current interface summary is displayed here.
Enter interface name used to connect to the management network from the above
interface summary:
GigabitEthernet0/0
Configuring interface GigabitEthernet0/0:
Configure IP on this interface? [no]:
yes
IP address for this interface:
<management ip address>
Subnet mask for this interface [255.0.0.0]:
<subnet mask>
Note:
The configuration command script is displayed here.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]:
2
2.4
Configure Jumbo Frames, LLDP, and Spanning Tree
Switch(config)#
system mtu 9198
Switch(config)#
lldp run
Switch(config)#
spanning-tree mode pvst
