Dell C9000 series, Справочное руководство

Страница: 666 / 2286

Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information This command applies the service-policy based on the type of protocol defined in the
ACL rules.
Create ACL and QoS policies prior to enabling this command.
If you configure rate-limiting of control protocols on a per-protocol basis and if you
modify the rate using the
rate-police
command in QOS-POLICY-IN mode while
traffic is being passed, packet drops for the specified protocols may occur if you
configure a rate higher than the default rate for a protocol.
Related
Commands
ip access-list extended cpu-qos — creates an extended IP ACL for CoPP.
mac access-list extended cpu-qos — creates an extended MAC ACL for CoPP.
class-map cpu-qos — creates a QoS class map for CoPP.
qos-policy-input cpu-qos — creates a QoS input-policy map for CoPP.
policy-map-input cpu-qos — creates an input-policy map for CoPP.
show control-traffic protocol
Display per-protocol counters of rate-limited control-plane traffic.
C9000 Series
Syntax
show contol—traffic protocol [cp—switch | linecard slot-id portset
port-pipe | pe pe-id stack-unit unit-number portset port-pipe ]
counters
Control Plane Policing (CoPP) 666