Dell C9000 series, Справочное руководство

Страница: 1467 / 2286

• The status of the IPv4 interface is UP only if the Layer 3 status of the interface is
UP and the interface has a valid IP address.
• The Layer 3 status of an IPv4 interface goes DOWN when its Layer 3 status goes
down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is
removed from the routing table.
Related
Commands
• show track – displays information about tracked objects, including configuration,
current state, and clients which track the object.
• track interface line-protocol – configures object tracking on the line-protocol
state of a Layer 2 interface.
track interface line-protocol
Configure object tracking on the line-protocol state of a Layer 2 interface.
C9000 Series
Syntax
track object-id interface interface line-protocol
To return to the default setting, use the
no track object-id
command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
interface Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter
gigabitethernet
and the slot-number/ port-number.
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords
port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter
tengigabitethernet
and the slot-number/ port-
number.
• For a VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Object Tracking 1467