Steps
1. Place the keyboard on the palm-rest assembly.
2. Replace the 39 (M1.2x1.6) screws that secure the keyboard to the palm-rest assembly.
3. Place the keyboard bracket on the keyboard.
4. Replace the 14 (M1.2x2.1) screws that secure the keyboard bracket to the keyboard.
5. Connect the keyboard cable to the keyboard-controller board and close the latch.
6. Connect the keyboard-backlight cable to the keyboard controller board.
7. Replace the two (M2x1.9) screws that secure the keyboard-backlight cable to the keyboard-controller board.
Next steps
1. Install the
.
2. Install the
3. Install the
4. Install the
5. Install the
.
6. Install the
7. Install the
.
8. Install the
. (if applicable)
9. Install the
. (if applicable)
10. Install the
.
11. Follow the procedure in
After working inside your computer
.
Palmrest
Removing the palm rest
Prerequisites
1. Follow the procedure in
Before working inside your computer
2. Remove the
3. Remove the
4. Remove the
. (if applicable)
5. Remove the
6. Remove the
7. Remove the
8. Remove the
9. Remove the
10. Remove the
11. Remove the
.
12. Remove the
13. Remove the
14. Remove the
.
15. Remove the
.
16. Remove the
.
17. Remove the
.
Steps
After performing the pre-requisites, you are left with the palm rest.
56
Содержание Alienware m17 R2
