8.
Grab the back of the computer base in the center and pull down slightly so that the two system-board securing clips clear their slots, and then pull out
the system board.
Installing the System Board
1.
Follow all of the steps in "
Removing the System Board
" in reverse order.
2.
Turn on the computer.
3.
Insert the floppy disk or CD that accompanied the replacement system board into the appropriate drive and follow the instructions that appear on the
screen.
Back to Contents Page
1 M2 x 3-mm screws labeled "B" (4)
1 system-board securing clips (2)
NOTICE:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.
NOTE:
After replacing the system board, enter the computer Service Tag into the BIOS of the replacement system board.
