5
Dell Networking 300 Series Access Points
| Installation Guide
Contacting Dell
Copyright
© Copyright 2016 Hewlett Packard Enterprise Development LP. Dell™,
the DELL™ logo, and PowerConnect™ are trademarks of Dell Inc.
All rights reserved. Specifications in this manual are subject to change
without notice.
Originated in the USA. All other trademarks are the property of their
respective owners.
Open Source Code
This product includes code licensed under the GNU General Public
License, the GNU Lesser General Public License, and/or certain other
open source licenses. A complete machine-readable copy of the
source code corresponding to such code is available upon request.
This offer is valid to anyone in receipt of this information and shall
expire three years following the date of the final distribution of this
product version by Hewlett-Packard Enterprise Company. To obtain
such source code, send a check or money order in the amount of US
$10.00 to:
Hewlett-Packard Enterprise Company
Attn: General Counsel
3000 Hanover Street
Palo Alto, CA 94304
USA
Website Support
Main Website
dell.com
Contact Information
dell.com/contactdell
Support Website
dell.com /support
Documentation Website
dell.com /support/manuals
Figure 5
Mounting the Access Point
Connecting Required Cables
Install cables in accordance with all applicable local and
national regulations and practices.
Verifying Post-Installation Connectivity
The integrated LEDs on the access point can be used to verify
that the access point is receiving power and initializing
successfully (see
). Refer to the Quick Start Guide for
further details on verifying post-installation network
connectivity.
Configuring the 300 Series
Access Point Provisioning/Reprovisioning
Provisioning parameters are unique to each access point.
These local access point parameters are initially configured on
the controller which are then pushed out to the access point
and stored on the access point itself. Dell recommends that
provisioning settings be configured via the AOS Web UI only.
Refer to the AOS User Guide for complete details.
Access Point Configuration
Configuration parameters are network or controller specific
and are configured and stored on the controller. Network
configuration settings are pushed out to the access point but
remain stored on the controller.
Configuration settings can be configured via the AOS Web
UI or AOS CLI. Refer to the respective guides for complete
details.
Note: The instructions in this section are applicable to the
W-AP304 and W-AP305 only.
