Firmware Upgrade Procedure Dell™ Networking N2100 Series Switches
Page 6
## Flattened Device Tree from multi component Image at 70000074
Booting using the fdt at 0x70439d58
Image is not a fdt
Continuing to boot without FDT
Uncompressing Multi-File Image ... OK
boot_prep_linux commandline: console=ttyS0,115200n8 maxcpus=2 mem=1008m envaddr=0x1C400000
root=/dev/ram mtdparts=nand_iproc.0:4m(uboot),4m(uboot-
env),2m(shmoo),4m(sys_eeprom),32m(diags),32m(onie),-(open) ubi.mtd=open quiet
Starting kernel ...
recovery_signal_init:vaddr=0xFEC00000 mapped address=0x18000000
recovery_signal_init:setting GPIO-1 to output
recovery_signal_init:writing GPIO-1 high
starting pid 1013, tty '': '/etc/init.d/rcS'
starting pid 1145, tty '/dev/ttyS0': '/etc/rc.d/rc.fastpath'
Mounting /dev/mtdblock6 at /mnt/fastpath...done.
Mounting tmpfs at /mnt/application...done.
Dell Networking Boot Options
============================
Select a menu option within 3 seconds or the Operational Code will start automatically...
1 - Start Operational Code
2 - Display Boot Menu
Select (1, 2)#
Extracting Operational Code from .stk file...done.
Loading Operational Code...done.
Decompressing Operational Code...done.
Uncompressing apps.lzma
Uncompressing python.lzma
Installing Python
<185> Nov 27 18:53:09 0.0.0.0-0 General[fp_main_task]: unitmgr.c(6606) 1 %% Reboot 1 (0x1)
DMA pool size: 16777216
AXI unit 0: Dev 0xb547, Rev 0x01, Chip BCM56547_A0, Driver BCM56340_A0
SOC unit 0 attached to PCI device BCM56547_A0
Using a clock divider of 16 for mac_cclk
<186> Nov 27 18:53:18 0.0.0.0-1 General[fp_main_task]: bootos.c(191) 8 %%
Event(0xaaaaaaaa)
started!
<185> Nov 27 18:53:18 0.0.0.0-1 SIM[Cnfgr_Thread ]: sim_util.c(3889) 10 %% Switch was
reset due to operator intervention.
(Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
Console>
6.
After the switch has finished rebooting, log in and verify that the firmware has been updated to the
6.3.6.9
version using the
show version
command. A single switch will typically reboot in around two minutes. A
stack may take significantly longer to complete the upgrade process.
console#show version
Machine Description............... Dell Networking Switch
System Model ID................... N2128PX-ON
Machine Type...................... Dell Networking N2128PX-ON
Serial Number..................... 15114M0002LF
Manufacturer...................... 0xbc00
Burned In MAC Address............. 001E.C9E5.BD0F
System Object ID.................. 1.3.6.1.4.1.674.10895.3066
SOC Version....................... BCM56150_A0
HW Version........................ 1
CPLD Version...................... 16
