Dell 1642018871, Руководство по началу работы

Страница: 20 / 184

18
|
Installation and Startup
Installing the Input and Ground Wires
Terminal Position
1 2 3
3
Punch a hole in the terminal block cover for the input conduit using a Greenlee
®
punch or similar
device. The hole accommodates 3/4
”
or 1
”
IMC conduit.
4
Pull the input wire through the conduit, leaving approximately 2 ft (0.5m) of exposed wire. Attach
a flexible metal fitting to the end of the conduit.
5
Insert the conduit through the wiring access entry and attach the conduit fitting to the panel.
Strip 0.5
”
(1.5 cm) of insulation from the end of each incoming wire.
6
Connect the input and ground wires to the terminal block according to Table 1.
Table 1. UPS Wiring Specifications
Wire Function
Terminal
Position
UPS Wire Function
Terminal Wire
Size Rating*
Tightening Torque
Input
1 Input Ground
5.26–16 mm
2
(10–6 AWG)
2.49 Nm (22 lb in)
2 L2/Neutral In
3 L1 In
* Use a minimum:
S
10 AWG for equipment grounding wire, 75
_
C copper wire minimum
S
8 AWG for input line and neutral wires, 75
_
C copper wire minimum
7
Replace the terminal block cover.