Figure 72. Removing the MicroSD card
Next steps
1. Follow the procedure listed in
After working inside your system
2.
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked
on the cards during removal.
Steps
1. Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
System board jumpers and connectors
section.
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
Installing and removing system components
127
